Modeling and Simulation of Wood and Fly Ash Behaviour as Partial Replacement for Cement on Flexural Strength of Self Compacting Concrete
DOI:
https://doi.org/10.30564/jbms.v2i2.2948Abstract
Flexural strength was monitor and predicted on the application improving concrete strength with wood and fly as partial replacement for cement. The study observed the pressure from the constituent of these locally sourced material that has been observed from the study to influence the flexural strength through the effect from this locally sourced addictives, the study monitors concrete porosity on heterogeneity as it reflect on the flexural strength of self compacting concrete, other condition considered was the compaction and placement of concrete, these effects were monitored at constant water cement ratio from design mix, the behaviour from this effects on the concrete observed the rate of flexural growth under the influences of these stated conditions, the simulation expressed the reactions of these effects through these parameters monitored to influence the system, numerical simulations were also applied to the optimum curing age of twenty eight days, while analytical simulation was also applied, this concept are the conventional seven days interval that concrete curing were observed, these are improvement done on the study carried out by SachinPrabhu et al 2018, these locally sourced material were experimentally applied, the simulation predictive values is at the interval of seven days of curing, which was also simulated. the predictive values were compared with the experimental values of SachinPrabhu et al 2018, and both values developed best fits correlations, the study is imperative because the system considered the parameters used on experimental and observed other influential variables that were not examined, these were not observed in the experimental procedure, experts in concrete engineering will definitely find these concept a better option in monitoring flexural strength of self compacting concrete in general.
Keywords:
Modeling; Wood Fly Ash Partial Cement and Flexural StrengthReferences
[1] ACI (2010). "Report on high strength concrete." Report ACI 363R-10, Farmington Hills, MI, American Concrete Institute.
[2] ACI (2011). "Building code requirements for structural concrete and commentary." Report ACI 318-11, American Concrete Institute, USA.
[3] Ahmad, S., and Shah, S. (1982). "Stress-strain curves of concrete confined by spiral reinforcement." ACI.
[4] Carrasquillo, R. L., Nilson, A. H., and Slate, F. O. (1981). "Properties of high-strength concrete subject to short-term loads." Journal of the American Concrete Institute, 78(3), 171-178.
[5] Iravani, S. (1996). "Mechanical properties of high-performance concrete." ACI Materials Journal, 93(5), 416-426.
[6] Logan, A., Choi, W., Mirmiran, A., Rizkalla, S., and Zia, P. (2009). "Short-term mechanical properties of high-strength concrete." ACI Materials Journal, 106(5), 413.
[7] Shah, S., and Ahmad, S. (1994). "High performance concrete: properties and applications." New York, McGraw-Hill.
[8] Zhaoyu M; Moses M Mechanical Properties of High-Strength Concrete PhD Candidate, Department of Civil, Structural and Environmental Engineering, University at Buffalo, State University of New York.
[9] Perenchio, W. F., and Klieger, P. (1978). "Some physical properties of high-strength concrete." Portland Cement Association.
[10] Whittaker, A. S. (2012). "CIE 525: Concrete Design Class Notes."University at Buffalo, NY.
[11] Wight, J. K., and MacGregor, J. G. (2009). "Reinforced concrete: Mechanics and design (5th edition)." Pearson Prentice Hall, Upper Saddle River, NJ.
[12] Ephraim M.E. Ode .T. (2006) Specification for structural Application of concrete with 10mm (3/8) All – in Gravel Aggregate NEAM Vol 1 No 1.
[13] Eluozo, S.N. Ode .T. (2015) Mathematical model to monitor stiff clay compression index in wet land area of Degema Volume 6, Issue 12, pp. 59-72, Article ID: IJARET_06_12_007
[14] Eluozo, S.N. Ode .T. (2015) Mathematical model to predict compression index of uniform loose sand in coastal area of Degema, Rivers State of Nigeria. International Journal of Advanced Research in Engineering and Technology Volume 6, Issue 12, pp. 86-103, Article ID: IJARET_06_12_009
[15] Eluozo. S. N and Ode T, Modeling and Simulation of Compression Strength for Firm Clay in Swampy Area of Ahoada East. International Journal of Advanced Research in Engineering and Technology, 6(12), 2015, pp.73-85.
Downloads
How to Cite
Issue
Article Type
License
Copyright © 2021 Eluozo S.N., Dimkpa K
This is an open access article under the Creative Commons Attribution-NonCommercial 4.0 International (CC BY-NC 4.0) License.